Qlogic QLogic Fibre Channel Switch Guia do Utilizador descarregar pdf (Página 15)

3 – Event Messages

Alarm Events

59060-00 03 3-5

[A] [1003.0041] [Zoning objects which contain Fibre Channel (FC) Address Members not

being sent to remote switch on save, not supported in this mode]

Meaning: An attempt was made to assign a zone member by FC address

while Interop mode was disabled. When Interop mode is disabled,

zone membership must be defined by world wide name or

domain_ID and port number.

Action: Enable Interop mode or change the zone membership type.

[A] [1004.0001] [Port in active hard zone, but not installed or present on this switch.]

Meaning: A zone member in an ACL zone on this switch is defined with an

invalid port number.

Action: Examine the fabric and correct the zone membership.

[A] [1004.0005] [No communication from neighbor switch on port port_number with domain

ID domain_ID, lost route]

Meaning: This switch has not received a hello from the remote switch for 80

seconds. Discard routes learned through this link and renegotiate.

Action: None

[A] [1004.0008] [Eport Isolating due to ELP Incompatibility]

Meaning: An E_Port isolated due to an Exchange Link Parameter (ELP)

incompatibility.

Action: Review accompanying alarms for specific cause.

[A] [1004.0009] [Eport Isolating due to ESC Incompatibility]

Meaning: An E_Port isolated because the connecting switch failed to support

the standard routing protocol Fabric Shortest Path First (FSPF).

Action: Connect a compatible switch.

[A] [1004.000A] [Eport Isolating due to EFP Domain Overlap]

Meaning: An E_Port isolated because each fabric has a switch with the same

domain ID.

Action: Change the domain ID on one of the conflicting switches.

[A] [1004.000B] [Eport Isolating due to Switch Administratively Offline]

Meaning: An E_Port isolated because the local switch has been placed

offline.

Action: Configure the administrative state to Online to establish the link.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 29 30

Sem comentários

Qlogic QLogic Fibre Channel Switch Guia do Utilizador Página 15