Qlogic SANsurfer iSCSI HBA Manager Guia do Utilizador descarregar pdf (Página 113)

5 – Non-Interactive Mode Commands

Non-interactive Commands

SN0054621-00 E 5-29

-sbootcode

(Set Secondary Boot Target Information)

To set the secondary boot target and LUN, enter the -sbootcode command as

follows:

-sbootcode <hba_port_inst> <Boot Target> <Boot LUN>

Issuing this command saves the configuration data to an XML file portable to all

platforms supported by iSCSI. This command is not active for PPC.

For information on the interactive version of this command, see “Set Secondary

Boot Target Information (CLI Option -sbootcode)” on page 4-35.

For primary boot code, see “-pbootcode (Set Primary Boot Target Information)” on

page 5-24.

-sbootcodecid

(Set Alternative Client ID)

To set the alternative client ID (seven characters maximum), enter the

-sbootcodecid command as follows:

-sbootcodecid <hba_port_inst> <Alternative Client ID>

This command is not active for the Power PC (PPC).

For information on the interactive version of this command, see “Set Alternative

Client ID (CLI Option -sbootcodecid)” on page 4-36.

-sdmrc

To return the SDM library return code, enter the -sdmrc command as follows:

-sdmrc [Simple_Pattern]

When [simple pattern] is given, only the lines containing that string are

printed.

There is no corresponding interactive command for this function.

-sreset

(Reset Statistics)

To reset statistics to zero and count from this point forward, enter the -sreset

command.

-stadd

To add a send target for discovery, enter the -stadd command as follows:

-stadd <hba_port_inst> <ip address> [chapIndex] [<TGBCA> <value>]

Where <value> can be on or off; on causes the send target login to require

bi-directional CHAP.

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 183 184

Sem comentários

Qlogic SANsurfer iSCSI HBA Manager Guia do Utilizador Página 113