Qlogic SANbox 5600 Series Guia de Instalação descarregar pdf (Página 169)

B – Command Line Interface

Reset Command

59096-02 C B-47

radius

Resets the RADIUS configuration to the default values as described in

Table B-14.

security

Clears the security database and deactivates the active security set. The security

configuration value, autosave, and fabric binding remain unchanged.

services

Resets the switch services configuration to the default values as described in

Table B-15.

snmp

Resets the SNMP configuration settings to the factory default values. Refer to

Table B-13 for SNMP configuration default values.

switch

Resets the switch without a power-on self test. This is the default. This reset

disrupts traffic and does the following:

 Activates the pending firmware.

 Closes all management sessions.

 Clears the event log. To save the event log before resetting, refer to the ”Set

Log Command” on page B-76.

To reset the switch with a power-on self test, refer to the ”Hardreset Command” on

page B-34. To reset the switch without disrupting traffic, refer to the ”Hotreset

Command” on page B-37.

system

Resets the system configuration settings to the factory default values. as

described in Table B-16.

zoning

Clears the zoning database and deactivates the active zone set. The zoning

configuration values (autosave, default visibility) remain unchanged.

NOTE:  Because this keyword changes network parameters, the

workstation could lose communication with the switch.

 This keyword does not affect installed license keys.

1 2 ... 164 165 166 167 168 169 170 171 172 173 174 ... 279 280

Sem comentários

Qlogic SANbox 5600 Series Guia de Instalação Página 169