Qlogic SANbox2-8c Guia de Instalação descarregar pdf (Página 183)

B – Command Line Interface

Set Port Command

59042-08 A B-75

Set Port Command

Sets port state and speed for the specified port temporarily until the next switch

reset or new configuration activation. This command also clears port counters.

Authority Admin session except for the Clear keyword.

Syntax set port [port_number]

bypass [alpa]

clear

enable

speed [transmission_speed]

state [state]

Keywords [port_number]

Specifies the port. Ports are numbered beginning with 0.

bypass [alpa]

Sends a Loop Port Bypass (LPB) to a specific Arbitrated Loop Physical Address

(ALPA) or to all ALPAs on the arbitrated loop. [alpa] can be a specific ALPA or the

keyword ALL to choose all ALPAs.

clear

Clears the counters on the port. This keyword does not require an admin session.

enable

Sends a Loop Port Enable (LPE) to all ALPAs on the arbitrated loop.

speed [transmission_speed]

Specifies the transmission speed for the specified port. Choose one of the

following port speed values:

1Gb/s

One gigabit per second.

2Gb/s

Two gigabits per second.

Auto

The port speed is automatically detected.

1 2 ... 178 179 180 181 182 183 184 185 186 187 188 ... 255 256

Sem comentários

Qlogic SANbox2-8c Guia de Instalação Página 183