Qlogic SANbox2-8c Guia do Utilizador descarregar pdf (Página 72)

4 – Managing Switches

Setting Temperature Thresholds

4-12 59022-05 A



4.6

Setting Temperature Thresholds

You can set temperature thresholds by which the switch will generate an alarm or

place the switch offline. The Temperature Thresholds dialog shown in Figure 4-6

prompts you to enter a warning threshold and a failure threshold temperature in

°C.

■ If the switch internal temperature exceeds the warning threshold, the switch

generates an alarm.

■ If the switch internal temperature exceeds the failure threshold and the

Enable Temperature Failure Port Shutdown box is checked, the switch

generates an alarm and places all ports offline.

Figure 4-6 Temperature Thresholds

4.7

Resetting a Switch

Resetting a switch reboots the switch using configuration parameters in memory.

You can reset a switch in the following ways:

■ Select the switch to be reset in the fabric tree. Open the Switch menu and

select Reset Switch.

■ Open a Telnet session and enter the Reset Switch command.

■ Power cycle the switch.

4.8

Configuring a Switch

Switch configuration is divided into two areas: chassis configuration and network

configuration. Chassis configuration specifies switch-wide Fibre Channel settings.

Network configuration specifies Ethernet and SNMP settings.

To open the Switch Properties window, open the Switch menu and select Switch

Properties. You may also right-click a switch graphic in the topology display or

faceplate display, and select Switch Properties from the popup menu.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 217 218

Sem comentários

Qlogic SANbox2-8c Guia do Utilizador Página 72