Enables the adapter to directly access memory above 4 gigabytes with 64-bit
Direct Memory Access addressing.
Valid Values 0 (disable) or 1 (enable)
Default Value 0
hba0-enable-LIP-reset
Enables the adapter to issue a LIP reset during Fibre Channel reset. Only one
of the variables hba0-enable-LIP-reset, hba0-enable-LIP-full-login, and hba0-
enable-target-reset should be enabled at the same time.
Valid Values 0 (disable) or 1 (enable)
Default Value 0
hba0-enable-LIP-full-login
Enables the adapter to issue a LIP full login reset during Fibre Channel reset.
Only one of the variables hba0-enable-LIP-reset, hba0-enable-LIP-full-login,
and hba0-enable-target-reset should be enabled at the same time.
Valid Values 0 (disable) or 1 (enable)
Default Value 1
hba0-enable-target-reset
Enables the adapter to issue a LIP target reset during Fibre Channel reset.
Only one of the variables hba0-enable-LIP-reset, hba0-enable-LIP-full-login,
and hba0-enable-target-reset should be enabled at the same time.
Valid Values 0 (disable) or 1 (enable)
Default Value 0
hba0-enable-database-storage
Enables the driver to save device position on the Fibre Channel bus.
Valid Values 0 (disable) or 1 (enable)
Default Value 0
hba0-scsi-reset-delay
Delay after a reset before sending commands to the devices on the Fibre
Channel bus.
Valid Values 0 - 255000 (millisec)
Default Value 5000
hba0-link-down-error
Disables all link down time out values if set to 0. The sd driver will not be
notified
of any error conditions if the qla2100 driver detects a link down condition. If
the
Symmetrix goes off line or the link with the host is broken for any reason, the
qla2100 driver holds all pending I/Os indefinitely until the link is restored or
the
Symmetrix rejoins the loop. In a Power Path environment this variable should
be turned on (1) so the PowerPath driver will be notified of any error
conditions.
Valid Values 0 or 1 (see Table 9-3)
Default Value 0
hba0-port-down-retry-count
Number of command retries to be done when devices are not responding on
the Fibre Channel bus. Large values may cause long delays for fail over
software to detect a failing device.
Valid Values 0 - 255
Default Value 5
(12 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais