Qlogic Fibre Channel NPIV Storage Networking Guide Especificações descarregar pdf (Página 21)

2-NPIV SAN Migration: Server Preparation

Sample Solution Configuration

2-3

Sample Solution Configuration

Figure 2-1 Quick Migration Configuration Example is an example of an NPIV

configuration that uses all of the system elements discussed earlier in this

section. A real-life data center is a more complex version of the same

configuration.

Figure 2-1. NPIV SAN Quick Migration Configuration Example

In Figure 2-1 Quick Migration Configuration Example, Server A and Server B

are the Hyper-V host servers, with installed QLogic Fibre Channel adapters.

These servers are connected to the SAN through an NPIV-enabled switch. Both

Server A and Server B are part of a Windows Active Directory domain hosted by

Server C. Server A is also the VMM2008 R2 server.

The software that resides on Server C (QLogic SANsurfer FC HBA Manager

or SANsurfer FC HBA CLI) allows the remote host bus adapter configuration on

Server A and Server B. Server C acts as a domain and DNS controller.

Installing the Software

This section describes how to install and enable Windows Server 2008 R2, as

well as the roles and features required for NPIV SAN Migration.

In addition to Windows Server 2008 R2, you must install VMM2008 R2, QLogic

Fibre Channel adapter device drivers, the SANsurfer FC HBA Manager GUI, and

the HP VDS Hardware Provider software.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 77 78

Sem comentários

Qlogic Fibre Channel NPIV Storage Networking Guide Especificações Página 21