Qlogic iSR6142 Manual do Utilizador descarregar pdf (Página 7)

SN0051408-00 C 7

8. Connect the iSR6142 routers to the Fibre Channel switches:

a. If the Fibre Channel switch is from Brocade, then the switch port connected to the routers must have

its port ISL mode set to enable R_RDY mode, as shown in Figure 3-5.

NOTE:

Both the QRouter CLI and iSCSI/FC Router Manager have an option to choose the outbound port

(management, iSCSI1/GE1, or iSCSI2/GE2), packet count, and destination IP address. Pinging the

remote router’s IP addresses from the local router verifies that the router ports can communicate with

each other.

NOTE:

The Fibre Channel switches must be switches from the same manufacture and must be compatible.

The switch ports connected to the router may need to be set to E_Port (expansion port). The FCIP link

between the Fibre Channel switches becomes an ISL; consequently, the switches are merged (SANs).

For the ISL to function correctly, the switches must be in auto-domain ID mode, or have been assigned

different domain IDs. In addition, the zone names on the switches must be unique; the switches cannot

have identical zone names before connecting the routers.

1 2 3 4 5 6 7 8 9 10 11 12

Sem comentários

Qlogic iSR6142 Manual do Utilizador Página 7