Qlogic Storage Networking (Unified Fabric Pilot) Guia do Utilizador descarregar pdf (Página 99)

Once the XenServer installation starts, after initially setting the Keyboard map the following screen appears:

1. At this stage change the KVM Virtual Media so that the QLogic .iso is connected, then select ―Local

Media.‖

2. Press ―F9‖ to load additional Drivers and install the available QLogic Drivers.

Note: This process is repeated at the end of the actual XenServer Installation as at this stage you are only defining a

supplemental pack for the later installation of the drivers.

3. On the Networking option select ―eth0‖ as the management Interface.

4. Once complete you are returned to the ―XenServer Setup‖ screen, change the KVM Virtual Media and re-

connect the XenServer Installation .iso; continue the installation using the ―Local media‖ option.

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 140 141

Sem comentários

Qlogic Storage Networking (Unified Fabric Pilot) Guia do Utilizador Página 99